MTX Series Matrix Switcher
PTN Electronics Limited www.PTN-electronics.com
18
2、 Transfer all input signals on [Y] card to the corresponding output channels respectively:
&[Y] + All#.
Example: If the command “&1+All#” is carried out, the status of the first card will be: 1->1, 2->2,
3->3, 4->4……8->8.
3、 Switch off all the output channels on [Y] card: &[Y]+ All$.
Example: After running the command “&3+All$”, there will be no signal output on the third card.
4、 Check the version of the firmware: /^Version;
To check the version of the firmware, run command “/^Version”.
5、 Switch off the detail feedback command from the COM port: /:MessageOff;
Switch off the detail feedback information from the COM port. But, it will leave the “switch OK” as
the feedback, when you switch the matrix.
6、 Switch on the detail feedback command from the COM port: /:MessageOn;
Switch on the detail feedback information from the COM port. It will show the detail switch
information when it switches. Example: when switch 1->2 for Audio, it will feedback “A0102”.
7、 Transfer signal on [Y] card from an input channel to the corresponding output channel:
&[Y]+[x]#.
Example: To transfer signal of the fourth card from the input channel No.5 to the output channel
No.5. Run Command: “&4+5#.”
8、Switch off an output channel of [Y] card: &[Y]+[x]$.
Example: To switch off the output channel No.5 on the first card. Run Command: “&1+5$.”
9、Switch the signal on [Y] card, from [x1] to [x2]: &[Y]+[x1] B[x2].
Example: To transfer the signal of the fifth card, from the input channel No.8 to the output channel
No.3,6,7. Run Command: “&5+8B3,6,7.”
10、Inquire the input channel to the output channel [x] of [Y] card: &[Y]+Status[x].
Example: To inquire the input channel to the output channel No.7 of the first card. Run Command:
“&1+Status7.”
11、Inquire the input channels to the output channels one by one, of [Y] card: &[Y]+Status.
Example: To inquire the input channels to the output channels one by one of the first card. Run
Command: “&1+Status.”
12、Save the present operation to the preset command [Z]: Save[Z].
Example: To save the present operation to the preset command No.7. Run Command: “Save7.”
13、Recall the preset command [Z]: Recall[Z].
Example: To recall the preset command No.5. Run Command: “Recall5.”
14、Clear the preset command [Z]: Clear[Z].
Example: To clear the preset command No.5. Run Command: “Clear5.”
7.2 RS232 codes of MXPA8
Communication protocol:
Baud rate: 9600 Data bit: 8 Stop bit: 1 Parity bit: none
RS232
commands
Function Desctription
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales